Malco C5A2 Crimper Power Assisted Impact Driver
Malco C5A2 Crimper Power Assisted Impact Driver
Get the competitive edge with a labor and cost saving TurboCrimper Impact driver attachment. Based on actual field trials, the TurboCrimper Impact is 78% faster than using a manual sheet metal crimping tool!
This sheet metal crimping attachment is designed to work with a minimum 12 volt DC cordless or maximum 7 amp AC corded IMPACT DRIVER. No set up or adjustment is needed. Immediately begin crimping multiple sizes, types, and thicknesses of round metal duct (Including spiral duct and metal stove pipe). It's also easy to balance while using and stores comfortably in a pouch or bag when not in use.
Attention: Use Impact Driver Only! Minimum 12V DC Impact Driver With Quick Release 1/4 in. Hex Chuck.
See "Related Products" below for more options.
Malco C5A2 Crimper Power Assisted Impact Driver
FEATURES
- The TurboCrimper Impact is 5 times faster than a manual sheet metal crimper.
- Saves time and labor on your next job.
- No setup or adjustment is needed, just chuck up and go.
- Easily stored in a bag or pouch when not in use.
SPECIFICATIONS
Catalog # | Description | Impact Driver Requirements | Chuck Requirements | Net Weight oz(g) | |
---|---|---|---|---|---|
C5A2 | TurboCrimper IMPACT Sheet Metal Crimping Tool | Min 12V DC, Max 7A AC | 1/4 Hex, Quick Release | 30 (848) | |
C5A2RD EV | Replacement Drive Shaft |
Capacities: Ga (mm)
Galvanized Steel 30 – 24 Gauge | Cold Rolled Steel 30 – 24 Gauge |
.016 – .034 (0.41 – 0.71) | .016 – .034 (0.31 – 0.61) |
Write Your Own Review